|
 |
|
Products - Modules
VDIP Modules make prototyping Vinculum designs a snap.
The VDIP modules are MCU to USB host controller development modules for the
VNC1L device.
VDIP1 is supplied on a PCB designed to fit a 24-pin DIP socket and provides access to all UART, SPI and FIFO interface pins of the
VNC1L device.
The VDIP2 is supplied on a PCB designed to
fit into a 40 pin DIP socket, and provides
access to the UART, parallel FIFO, and SPI
interface pins on the
VNC1L
device, via its AD and AC bus pins. All other
Vinculum I/O pins are also accessible.
Ideal for rapid prototyping and development of
VNC1L designs, an attractive quantity discount structure also makes this module suitable for incorporation into low/medium volume finished product designs.
VDIP2
VDIP2 Module
|
|
Key VDIP2 features include:
► Two vertically mounted USB
"A" type sockets to interface with
USB peripheral devices
► Uses FTDI's
VNC1L device
► Jumper selectable UART,
parallel FIFO or SPI MCU interfaces
► Single 5V supply input
► Auxiliary 3.3V/200mA power
output to external logic
► Power and traffic
indicator LEDs
► Program or update firmware
via USB Flash disk or or via UART
interface
► VNC1L firmware programming
control pins PROG# and RESET#
brought out onto jumper interface
► VDIP2 is a Pb-free, RoHS
complaint development module
► VDIP2 module is supplied
pre-loaded with Vinculum
VDAP firmware
|
VDIP1
VDIP1 Module
|
|
Key VDIP1 features include :
► Jumper selectable UART, SPI or FIFO MCU Interfaces
► Uses FTDI's
VNC1L device
► USB "A" type socket to interface with USB peripherals
► 2nd USB Interface available via module pins if required
► Single 5V supply input
► Auxiliary 3.3V/200mA power output to power external logic
► Power Good and Traffic Indicator LEDs
► RESET# and PROG# signals allow device programming via the
UART interface if required.
|
|
|
|
|
