|
 |
|
Products - Modules
VDRIVE - easily add USB Flash Drive interface to products.
VDRIVE is possibly the easiest solution for adding a USB Flash drive interface to existing products. Only four signal lines plus 5V/GND require to be connected. Using the VDAP firmware, the interface can be selected between UART or SPI modes using the on-board jumpers. VDRIVE is ideal for use in commercial products such as domestic goods, set top box, etc. as well as industrial products such as data loggers, software upgradeable products, etc.
VDRIVE2
VDRIVE2 Interface Module
|
|
Key VDRIVE2 features include:
► Uses FTDI's VNC1L embedded
USB host controller IC device
► One USB "A"
socket to connect to USB Flash disk
► Traffic
indicator LED
► 2mm (0.08")
pitch 8-pin connector
► 8-way
header interconnect cable provided
► Only 4 signals to connect excluding PWR/GND
► Jumper selectable UART or SPI interface
► Single 5V supply input
► Uses VDAP firmware and command set
► Enclosure with snap in
place clips allows for easy front
panel mounting
► Program or update firmware
via USB Flash disk or UART interface
► VNC1L firmware programming
control pins PROG# and RESET#
brought out onto internal jumper
interface
► VDRIVE2 is a Pb-free, RoHS
compliant development module
► A PCB only version is
available for larger volume OEM
customers
|
VDRIVE1
VDRIVE1 Interface Module
|
|
VDRIVE1 is no
longer available for general
purchase, but
is available for larger volume
OEM customers.
Key VDRIVE1 features include:
► One USB "A"
socket to connect to USB Flash disk
► Uses FTDI's VNC1L device
► Link selectable UART or SPI interface
► Only 4 signals to connect excluding PWR/GND
► 0.1" (2.54mm) pitch 6-pin
connector compatible with
TTL-232R-3V3 for easy evaluation
► Single 5V supply required
► Uses VDAP firmware and command set
|
|
|
|
|
